Glossary entry (derived from question below)
English term or phrase:
bus topology
Norwegian translation:
busstopologi
Sep 1, 2009 15:59
14 yrs ago
English term
bus topology
GBK
English to Norwegian
Tech/Engineering
Automation & Robotics
Definition from
Manufacturing Automation:
A link topology in which all stations are connected in parallel to a medium. These stations are capable of concurrently receiving a signal transmitted by any other station connected to the medium.
Example sentences:
Bus topology has some disadvantages. When there is heavy traffic on cables then bus topology will not work properly. Sometime due to heavy traffic network may stop working. (blurtit)
With the Bus topology, all workstations are connect directly to the main backbone that carries the data. Traffic generated by any computer will travel across the backbone and be received by all workstations. This works well in a small network of 2-5 computers, but as the number of computers increases so will the network traffic and this can greatly decrease the performance and available bandwidth of your network. (firewall.cx)
To avoid signal reflection, a physical bus topology requires that each end of the physical bus be terminated. (brainbell.com)
Proposed translations
(Norwegian)
5 +2 | busstopologi | Egil Presttun |
Change log
Sep 1, 2009 15:56: changed "Kudoz queue" from "In queue" to "Public"
Sep 1, 2009 15:59: Enrique Cavalitto changed "Stage" from "Preparation" to "Submission"
Sep 4, 2009 16:35: Mauricio Zoch changed "Stage" from "Submission" to "Selection"
Sep 4, 2009 17:54: changed "Stage" from "Selection" to "Completion"
Proposed translations
+2
24 mins
Selected
busstopologi
Definition from
Hardware.no:
En kabel i nett i et nettverk kan strekkes på forferdelig mange måter. Den måten vi strekker kabelen vår på kalles gjerne for topologi. Buss, ring og stjerne er hovedtopologiene. Men vi skal i første omgang se på buss og stjerne. Busstopologi:<br />Bussnettverk er basert på en lang coax kabel (RG 58, 50 Ohm) som strekker seg mellom alle maskinene i nettverket. Kabelen er koblet til hver enkelt maskin med en BNC plugg og et T-ledd. På slutten av kabelen setter man en 50 Ohms terminator.
4 KudoZ points awarded for this answer.
Something went wrong...